A direct-current motor, controlled by a microprocessor electronic board, operates the other Fisiotek 2000 units. All functions can be programmed by using the on-board control panel. START and STOP keys are also available on a hard-held control, so that patients can start and stop movement if needed.
The unit can be adjusted to fit the patient according to the limb length, as measured from the greater trochanter to the malleolus.
This device allows the knee and hip to be mobilized through flexo-extension movements.
This device can accommodate limbs that are 32-46 cm long, which is equivalent to a patient's height of about 140-190 cm, respectively.
PROGRAMMABLE FUNCTIONS:
- knee flexo-extension range from -5° to 110°;
- flexion speed from 1.5 to 3.5°/sec;
- force 0-40 kg;
- session time;
- pause during flexion/extension.
Automatic extension and flexion angle increase.
Warm-up cycles.
With Memory Card.